Hello all

I recently imported the latest Exchange MP I am trying to tune the “IS RPC Latency consecutive samples monitor” and the “IS RPC Latency Monitor.” when I look at the threshold comparison tab on the consecutive samples monitor, I see Value =greater than 50.00. Is this number in milliseconds? In the Number of samples I see a value of 3. Putting this altogether does this monitor alert when it detects that the Rpc Average latency counter has gone over 50. Milliseconds for three consecutive samples? Is there a dependency with these two monitors?

The reason why I am asking is because when an alert is generated for the “IS RPC Latency Monitor”  the current value is much lower than 50. Also soon after the monitor raises an alert I get another alert from the IS RPC Latency Monitor  consecutive threshold telling me that value is greater than the threshold for 3 times

Alert: RPC latency is outside the calculated baseline

Source: Information Store

Path: irv-edc-ms03.corp.kbb.com;IRV-EDC-MS03

Last modified by: System

Last modified time: 3/19/2009 7:54:11 AM Alert description: The RPC latency is outside the calculated baseline. The current value is 11.3333333333333

Alert: RPC latency is above the threshold

Source: Information Store

Path: irv-edc-ms03.corp.kbb.com;IRV-EDC-MS03

Last modified by: System

Last modified time: 3/19/2009 8:14:10 AM Alert description: The RPC latency is above the threshold. The value is greater than the threshold for 3 times.

==============
Missed an email? Check out the list archive:
http://myitforum.com/cs2/blogs/momlist/